Pierce Enforcer

Question 1

Pierce Enforcer length?

Answer 1

31’ 1”

Question 2

Pierce Enforcer width?

Answer 2

10’

Question 3

Pierce Enforcer height with deck gun?

Answer 3

10’ 7”

Question 4

Pierce Enforcer weight?

Answer 4

46,500lbs 23.25 tons

Question 5

Pierce Enforcer fuel capacity?

Answer 5

65 gallons

Question 6

Def capacity for Pierce Enforcer?

Answer 6

4.5 gallons

Question 7

Pierce Enforcer engine oil?

Answer 7

28 quarts 15w40

Question 8

Pierce Enforcer transmission fluid?

Answer 8

19 quarts

Question 9

Pierce Enforcer engine coolant?

Answer 9

33 quarts

Question 10

Pierce Enforcer pump?

Answer 10

Waterous 1500 GPM

Question 11

Pierce Enforcer booster tank capacity?

Answer 11

500 gallons

Question 12

Pierce Enforcer front tires?

Answer 12

125psi F-35/80/22.5R

Question 13

Pierce Enforcer rear tires?

Answer 13

R-12R 22.5 120 psi

Question 14

Power steering for Pierce Enforcer?

Answer 14

4 quarts

Question 15

Pierce Enforcer ladder compliment?

Answer 15

24’ extension ladder, 14’ roof ladder, 10’ attic ladder

Question 16

Check engine oil, transmission oil and power steering reservoir on Pierce Enforcer by?

Answer 16

Access door in the cab in front of rear jump seats.

Question 17

Location of windshield washer fluid on Pierce Enforcer?

Answer 17

Located in compartment by officers right knee.

Question 18

How long should you wait after pushing the ignition button to allow the Pierce Enforcer rig to go through its pre-checks?

Answer 18

5-7 seconds

Question 19

After the engine in the Pierce Enforcer starts what should the adequate oil pressure read?

Answer 19

20-30psi

Question 20

What color is the parking brake button in the Pierce Enforcer?

Answer 20

Yellow

Question 21

What should the air pressure gauge read in the Pierce Enforcer after start up?

Answer 21

90-120psi

Question 22

What button do you push to allow the 5th gear in the Pierce Enforcer?

Answer 22

Mode button

Question 23

How long should you wait after you throw the pump lever down into the middle position for the Pierce Enforcer?

Answer 23

3-4 seconds

Question 24

What color is the OK TO PUMP light in the Pierce Enforcer?

Answer 24

Green

Question 25

For pump operations after engaging the transmission into drive what light should come on for the Pierce Enforcer?

Answer 25

The green pump engaged light should come on.

Question 26

If the pump engaged light is on in the cab what light should also be lit up at the pump panel on the Pierce Enforcer?

Answer 26

The green pump engaged light should also be lit up.

Question 27

What should the master discharge gauge be showing on the Pierce Enforcer?

Answer 27

A positive pressure.

Question 28

If the master discharge gauge for the Pierce Enforcer is not showing a positive pressure what should you start?

Answer 28

Start priming procedures with the Trident Air Prime.

Question 29

Where is the manual pump shift for the Pierce Enforcer?

Answer 29

Lower right side of the pump panel.

Question 30

How do you operate the manual pump shift on the Pierce Enforcer?

Answer 30

Place transmission in neutral (N) and then push the manual pump shift for ROAD and pull for PUMP.

Question 31

How do you operate the Trident Air Prime system?

Answer 31

Increase the throttle speed to 1000RPM. Depress the button on the panel and hold it down until the master discharge gauge begins to rise.

Question 32

How many preconnects are on the Pierce Enforcer?

Answer 32

6. Two 1.75” hand lines and one 2.5” hand line for crosslays. Two 2.5” discharges on the drivers side rear for the 2.5” preconnect and courtyard stretch. And one 1.75” front bumper handline.

Question 33

How many discharges are on the Pierce Enforcer?

Answer 33

4. Two 2.5” on drivers side pump panel. One 2.5” and one LDH discharge on the officer side pump panel.

Question 34

What are the specs for the booster line on the Pierce Enforcer?

Answer 34

1” booster reel is located on the top on the officer side. Rollers assist with deployment to either side. The rewind switch is located on the officer side pump panel.

Question 35

What is the deck gun for the Pierce Enforcer?

Answer 35

Task Force Tips deck gun.

Question 36

What is the operating range for the deck gun on the Pierce Enforcer?

Answer 36

70-120psi and 300-1500gpm

Question 37

Where are the controls for the deck gun on the Pierce Enforcer?

Answer 37

Pump panel, on the deck gun and the wireless controller.

Question 38

Where is the manual override for the deck gun?

Answer 38

It is by the nozzle and will allow you to manually transition from fog to straight stream. Additionally there are manual knobs for rotation and elevation if the motors do not operate.

Question 39

How many intakes are there for the Pierce Enforcer?

Answer 39

4. One 6” LDH intakes on both side panels and one 2.5” auxiliary intake on both side panels.

Question 40

Where is the cab lift control panel on the Pierce Enforcer?

Answer 40

Located on the officer side pump panel.

Question 41

Where is the safety bar on the Pierce Enforcer?

Answer 41

The safety bar is located on the driver side of the engine next to the power steering reservoir.