3M- Workcenter Supervisor - QB1

Question 1

3M is divided into what two sub-systems?

Answer 1

PMS (SKED) and MDS (OMSS-NG)

Question 2

What is SPMIG Category II

Answer 2

Materials

Question 3

The work center supervisor can make pen and ink changes to which block on the MRC

Answer 3

Tools and materials

Question 4

Who is responsible to review, approve and initial non-applicable procedural steps that are lined out?

Answer 4

LCPO

Question 5

What is a LOEP?

Answer 5

List of Effective Pages; list all MIPS and applicable maintenance for that work center

Question 6

What does MIP stand for?

Answer 6

• Maintenance index page

Question 7

What is a Local trigger?

Answer 7

• A Local event that affects that particular piece of equipment which requires situational PMS to be accomplished

Question 8

Who is responsible for the administration of their cognizant tag-out log?

Answer 8

• Authorizing Officer

Question 9

When does the 2nd checker sign a tag?

Answer 9

• After the 1st person signs a tag the 2nd person IDEPENDENTLY verifies the correct position and location of all Tags; then signs and places TORS in the Active section

Question 10

What is the purpose of the Instrument Log?

Answer 10

• To control document for administering labels (OOC and CAL)
• It provides sequential listing of all OOC and Cal instruments

Question 11

What are the different labels used in the Instrument Log and what colors are they?

Answer 11

• OOC- Red
• Out of Cal- Orange

Question 12

What is the purpose of a tag out audit?

Answer 12

• To ensure active tags are hung in the correct location, position and inactive tags are not still in place

Question 13

What periodicity is D-1?

Answer 13

Daily

Question 14

What periodicity is M-2?

Answer 14

Monthly

Question 15

What periodicity is Q-1?

Answer 15

Quarterly

Question 16

Monthly checks must be accomplished a minimum of _____ times per quarter.

Answer 16

3

Question 17

Multi-monthly checks GREATER than annual will be accomplished within the interval of plus or minus _____ Quarter of the quarter specified by the periodicity interval.

Answer 17

1

Question 18

What is the non-calendar periodicity code AP?

Answer 18

Assessment Procedure

Question 19

What are the two types of FBRs?

Answer 19

Non-Technical
Technical

Question 20

What are examples of Non-Technical FBRs

Answer 20

• Split MIP
• Shift PMS responsibility
• MIP deletion

Question 21

Feedback Reports are submitted under what circumstances?

Answer 21

• Maintenance requirements are not fully understood
• Errors are believed to exist on the MRC
• Entries in the TPMTE block are wrong or inadequate
• Performance of the maintenance requirement would cause a hazardous condition to exist

Question 22

What is IEM?

Answer 22

• Inactive Equipment Maintenance

Question 23

Which category of IEM is accomplished when placing an equipment in IEM?

Answer 23

• Lay-Up Maintenance

Question 24

How will the WCS implement the new force revision? 303.2.15
22

Answer 24

• Apply changes to the WC PMS schedule utilizing SKED Revision Editor
• Route revision changes to division LCPO for review and concurrence

Question 25

How do you validate a piece of equipment?

Answer 25

- use the Equipment Validation sheet and verify serial number, location, and name plate data. - Sign and update in OMMS-NG