Inflatable's General Info

Question 0

Decks where rafts are serviced, tested and maintained shall be covered with?

Answer 0

Linoleum, asphalt tile, polished terrazzo stone, tile, or a similar smooth, padded (rubber), clean surface

Question 1

You would never inspect a raft on what surfaces?

Answer 1

Carpet, asphalt, concrete, hardwood, or wood decks

Question 2

What kind of lighting for a raft shop?

Answer 2

Recessed or shrouded fluorescent lighting. Windows shall be fitted with protective blinds or drapes to exclude extended sunlight exposure. Which degrade synthetics and polybonded fabrics

Question 3

What should the temperature and humidity be for a raft shop?

Answer 3

Temp- 65-75 F.

Humidity- 40-60%

Question 4

What are the shop air requirements for an inflatable’s area?

Answer 4

Shop air will be regulated, no higher than 40 psig air from a source that is filtered to ensure no oil or moisture is present

Question 5

Shop air pressure shall be capable of constant pressure to ____ PSIG

Answer 5

100

Question 6

What process guide do you use to clean liferafts, containers/cases, and fabricate inspection streamers??

Answer 6

CGTO PG-85-00-310

Question 7

What does N/cm2 mean?

Answer 7

Newton per square centimeter

It’s a form of measuring pressure

Question 8

All life preservers and life vests will be inspected every?

Answer 8

180 days

Question 9

When equipment is received from ALC or another unit, what must be completed and entered into ACMS?

Answer 9

RECEIVE MPC

Question 10

Reference numbers for replacement parts that r defective and require replacement can be found where?

Answer 10

ALSIPS

Question 11

Life preserver and survival vest bladders shall be considered beyond repair when?

Answer 11

• porous fabric areas on tubes cause a visible leak
• split or open bladder seams
• holes, cuts, tears, or punctures over 1 in sq or within 1 inch of a seam on an LPP-1A

Question 12

There are no authorized repairs on the?

Answer 12

LPU-27/P, LPU-26/P, LPU-26/PE survival vest bladders, carrier, or bladder shell

Question 13

All condemned life preservers shall be used as drill gear, how will it be marked?

Answer 13

“DRILL ONLY” in 3/4 inch black letters on 1-inch white webbing attached to the container

Question 14

When cleaning inflatable’s how many parts of detergent to how many parts of water?

Answer 14

One part detergent to three parts water

Question 15

What is the MIL-D for detergent general-purpose?

Answer 15

MIL-D-16791

Question 16

Streamers for rafts are how long before sewn And what color?

Answer 16

36 in
Red
Sewn under 1/2th inch each side

Question 17

The wooden or rubber roller for cementing is how big?

Answer 17

2-inch diameter X 2-inch wide

Question 18

When cementing a raft Brush,___ medium, even coates allowing____ drying time between coats.

Answer 18

Three even coates

Allowing 10 minutes drying time

Question 19

Allow cement to cure for a minimum of how many hours with no internal pressure?

Answer 19

48 hours

Question 20

How many hours before you discard unused cement after mixing?

Answer 20

4 hours

Question 21

Talcum powder spec number?

Answer 21

A-A-59303