PATRIOT INVENTORY MANAGMENT Flashcards
(26 cards)
Logistics is
planning and executing the movement and support of forces.
Logistics consists of the following:
❑ Maintenance
❑ Transportation
❑ Supply
❑ Field Services
❑ Distribution
❑ Operational Contract Support
❑ General Engineering Support
Prescribed load consists of the following:
▪ ZV (Demand Supported)
▪ PD (Non-Demand Supported)
▪ ZP (Provision - New Equipment)
▪ ZM (Command Add)
Demand Supported (ZV lines) repair part requirements:
• This MRP type can only be assigned to a material by GCSS-Army. It cannot be
manually assigned by a User.
• This MRP type requires a reorder point quantity value.
Non-demand Supported (PD lines) repair parts:
- Limited to 15 lines.
- Must be essential (EC “C” listed in the AMDF on FEDLOG) and a maintenance use code of “O” (located in end item TM).
Initial Stockage (ZP Lines):
Provided as necessary for newly introduced end items.
These items do not count against Demand supported or Non-demand
Supported repair parts.
Materials with this MRP type are not considered for deletion by MRP for two
years.
Command Add (ZM lines) repair parts:
• Used for DMPL inventory.
(DMPL)
Diagnostic Mandatory Parts List
Diagnostic Mandatory Parts List
(DMPL)
is to maintain the highest possible state of
readiness through diagnosis and repair of faults in
NMC equipment and to ensure availability of
combat/mission essential assets at or near the firing
battery to preclude extended downtime for lack of
repair parts.
The DMPL is accessible in
IADS. EM 0197;TM 9-1425-600-24P-2
Zero balance
DMPl item used and replaced by bad part
Class A packing
Sealed
Class B packing
Opened package
Check what NSN changes?
Fed Log or PIG03
Commanders will ensure a _________ inspection of PLL is conducted
for active army units.
quarterly
Inventories are conducted using the
Physical Inventory Documents
created from GCSS-Army (MI31
________, directs inventories of PLL to be performed quarterly for
Active Army units.
AR 710-2
Shop stocks are
Class II, and IX repair parts and supplies located at
field- and below-depot sustainment maintenance activities
Bench stock consists of
low-cost consumables, repair parts, and
supplies used by maintenance shop personnel at an unpredictable
rate.
Bench stocks typically consist of common
hardware, resistors,
transistors, capacitors, wire, tubing, hose, ropes, webbing, thread,
welding rods, sandpaper, gasket material, sheet metal, seals, oils,
grease, and repair kits.
Quality Deficiency Report (QDR):
Used to report initial failures on a part.
Supply Deficiency Report (SDR):.
Used to report that the wrong part was
received
Submit QDR/SDR information to.
PDREP with Logistic Assistant Representative
(LAR) located at BN
Logistics is
planning and executing the movement and support of forces.
