Roof Top Safety (ER 10-18,19-18) Flashcards
3 requirements that apply 100% of the time a tech must go on a roof
- Contact Supervisor
- Complete a rooftop permit and have it signed by the trained supervisor
- Supervisor must be onsite for duration of the job
The top of any building that is ____ or higher from the ground or lower structure is considered a rooftop
6 feet
Equipment used to arrest falls of employees that consists of an anchorage point, connecting equipment (lanyard) and body harness
Personal fall arrest system
consists of equipment to keep an employee from reaching a fall point, such as the edge of a roof or the edge of an elevated working surface
Personal fall restraint system
if a permit is required to work on a roof, who must sign the permit prior to an employee going on the roof?
A trained Comcast supervisor
definition of a low slope roof
A roof having a slope less than or equal to 4 in 12 (vertical to horizontal)
The requirements for working on flat roofs are separated into what two different categories?
- Performing work that is within 15 feet from the edge of the roof
- Performing work that is greater than 15 feet from the edge of the roof.
Height of guard rails should be between
39” to 45”
safety nets must be installed no more than ______ below the working level.
30 feet
Warning lines must be erected at minimum ______from the roof’s edge.
6 feet
This is simply a person that is on the roof with you to make sure you do not get too close to the roof’s edge
Safety Monitoring System
Safety Monitoring systems are NOT permitted alone on roofs more than ____ in width
50 feet
A protective wall along the edge of a roof designed to protect employees from falling to a lower level
Parapet
Parapet requirements
- capable of withstanding a force of at least 200 pounds 2. a height of 42 inches above working surface
Personal Fall Arrest Systems must be rigged so the technician will free fall no more than ____ feet
6
