OQ-0994 Viscotaq Pipe Wrap

Question 1

Roughen the adjacent coating approximately blank inches

Answer 1

4 inches

Question 2

What can you use to roughen the coating?

Answer 2

Sandpaper (120 grit)
Hand or power wire brush

Question 3

Surface shall be kept clean and free of grease with what?

Answer 3

Isopropyl alcohol (min 90%) or aervoe hand y wipe

Question 4

What do you use to ensure the surface is free of moisture and dry to the touch?

Answer 4

Dry cloth

Question 5

What else can you use if the surface is still not dry after using a cloth?

Answer 5

Use a torch or heat gun to dry the surface

Question 6

What do you do if existing costing is thicker than 70 mils?

Answer 6

Apply one straight full circumference wrap to the bare steel next to the existing coating.

Question 7

Begin and end on existing coating with a blank inch overlap

Answer 7

4 inch

Question 8

Continue to wrap at a slight angle with minimum of blank overlap

Answer 8

1/2 inch

Question 9

When you finish the wrapping the base coating onto the existing coating, no less than blank inches, and with a straight circumference wrap 

Answer 9

4 inches

Question 10

When doing method 2 start by applying the coating a minimum of blank over the existing coating on either side

Answer 10

4”

Question 11

When doing method 2 wrap the pipe in a circumference around the pipe ending with a minimum of blank overlap 

Answer 11

1”