OW-0041 Installation And Maintenance Of Mechanical Electrical Connections

Question 1

Approximately blank above ground level

Answer 1

6”

Question 2

Clean a blank section of riser to bare metal

Answer 2

1-inch

Question 3

Install a blank or blank on the cleaned area

Answer 3

Copper band or gear clamp

Question 4

Cut off excess wire and strip back approximately blank of insulation

Answer 4

1” ( you do this when using copper band)

Question 5

Install blank the proper distance from riser

Answer 5

Anode

Question 6

Install blank into blank and tighten the nut until the wire is secure

Answer 6

Wire into clamp

Question 7

Ensure the connection is securely fastened by verifying with a what?

Answer 7

CP read

Question 8

Coat clamp with blank layer of rubber filler tape?

Answer 8

1

Question 9

Spiral wrap riser from blank below ground level to blank above clamp, taping the anode wire to the riser

Answer 9

2” below ground level
2” above clamp

Question 10

Verify read is what?

Answer 10

Above the minimum level and not above the maximum level

Question 11

Buldging,blistering tape on riser is a what?

Answer 11

UOC

Question 12

Buried stopcock is a what?

Answer 12

UOC

Question 13

Ground level riser buried too deep is a what?

Answer 13

UOC

Question 14

Bare or unprotected steel pipe at ground level is a what

Answer 14

UOC