Peter's Questions V2500

Question 1

The variable bleed valve system consists of:

A. A master bleed valve and seven slave valves
B. A master bleed valve and eleven slave valves
C. A bleed ring operated by two actuators
D. Four pivoting doors

Answer 1

A bleed ring operated by two actuators

Question 2

Where is the fuel filter located?

Answer 2

In the FCOC

Question 3

A thrust lever angle of <-3° and a rad alt of less than 10 ft will:

A. Allow the SECs to open the hydraulic shut off valve for the thrust reverser
B. Allow the EIU to close the inhibition relay for the thrust reverser
C. Allow the SECs to deploy the thrust reverser
D. Put the throttles to the take off position

Answer 3

Allow the SECs to open the hydraulic shut off valve for the thrust reverser

Question 4

With air conditioning and anti-ice selected, what will happen to the idle speed of the engine?

Answer 4

It will go from minimum idle to approach idle

Question 5

The high pressure turbine clearance control valve uses what air?

Answer 5

Fan air

Question 6

Which fuel component distributes fuel to the fuel nozzles?

Answer 6

Fuel distribution valve

Question 7

Which engine mount transmits only axial loads to the pylon?

Answer 7

Neither

Question 8

Which of the modes for the FDRV is the failsafe mode?

Answer 8

Mode 5

Question 9

Where are the P2/T2 sensors located?

Answer 9

In the fan inlet cowl

Question 10

How many stages of HP compressor has the V2500?

Answer 10

10

Question 11

When is the PRSOV in the FMU energised?

Answer 11

For two minutes after shut down

Question 12

115VAC from the aircraft is supplied to the relay box by:

A. The EEC
B. The EIU
C. The dedicated alternator
D. The static inverter

Answer 12

The EIU

Question 13

What is the maximum EGT allowed during start on the ground?

Answer 13

635°C

Question 14

At 10% N2, what supplies the EEC with power?

Answer 14

The dedicated alternator

Question 15

Which bearings support the N1 shaft?

Answer 15

1, 2 and 5

Question 16

At 43% N2 during a ground start, what happens?

Answer 16

The ignition and starter are disengaged

Question 17

If XX is displayed on any gauge on either the EWD or SD, what does this indicate?

Answer 17

Sensor failure