Flashcards in OES (12-16-19) Deck (157)
ANSI/SCTE 02 2015
Specification for "F" Port, Female, Indoor
F-connectors on all Comcast-provided CPE must be securely tightened to
maximum of 10 inch-pounds
BER Post-FEC Minimum Threshold at CPE
ANSI/SCTE 129 2017
Drop Passives: Bonding Blocks
what must be done to unused ports on a splitters?
install a terminator with a 75-ohm resistor
Underground drop cables routed down a pole must have physical protection, cable guard or conduit, to a point at least ______above ground.
What must be in amplifiers with a passive port to prevent ingress in the event DC power is removed?
a mechanism to properly terminate the internally amplified legs.
PE cable jacket
Polyethylene cable jacket
The protective conduit or molding for underground drops must extend at least_____below ground at the house.
. If a cable is damaged under a sidewalk or driveway, new cable must be
placed for that portion and must be spliced a minimum of ___ from the edge of
the sidewalk or driveway.
All F-connectors must be
compression-type with 360-degree retention of the cable
Bonding option 2
power company ground conductor (ground wire)
Underground drop cables routed down a pole must have physical protection, cable guard or conduit, to a point at least ______ below ground.
In an underground installation, what must be used between the tap port and the
National Electrical Safety Code
What must be done to a locking terminator if a drop is parked on the bottom of it?
it must be sealed to prevent moisture contamination
ANSI/SCTE 74 2011
Specification for Braided 75 ohm Coax Drop Cable
What should a temporary drop run along to prevent tripping or entanglement?
an existing fence line
Drop clearance over roads, streets, alleys; nonresidential driveways ; parking lots and other areas subject to truck traffic
F-81 drop splice barrel connectors must have a non-threaded area at the base to accommodate what?
Cable used for underground installations must have what on the braid wires?
a flowing, self-healing flooding compound
How often should compression tools be inspected?
Upstream SNR Minimum Level
what part of floor/ceiling joist span is prohibited from drilling through?
the middle one-third
requirements for mounting wall plates
same height as the electrical outlets and no closer than 6 inches from any electrical outlet
the grounding conductor is made of
When routing the underground drop parallel to lot lines, routing must stay
4 feet away from those lines
Cables used for aerial installations must have what on the braid wire?
a non-flowing flooding compound
Only as a last resort, drilling of a foundation will require