SCBA maintenance Cleaning procedures231-03

Question 1

Who is responsible for ensuring that the SCBA is checked for proper operation?

Answer 1

All Regina Fire & Protective Services (RFPS) personnel that will be required to wear a SCBA

This responsibility is critical for safety prior to SCBA use.

Question 2

When should the Daily In-Service SCBA Equipment Check be performed?

Answer 2

The procedures described in RFPS SOP 231-04 should be done:
* At the commencement of each shift
* Following an incident where the SCBA was in operation
* Whenever the SCBA has been cleaned after use
* When personnel are reassigned to a different apparatus
* Whenever an officer deems it necessary

These checks ensure the SCBA is functioning correctly and safely.

Question 3

Fill in the blank: The procedures for SCBA checks are outlined in RFPS SOP _______.

Answer 3

231-04

This standard operating procedure provides detailed steps for SCBA checks.

Question 4

True or False: SCBA checks are only required at the commencement of each shift.

Answer 4

False

Checks are required under multiple circumstances, including after incidents and cleaning.

Question 5

What is the purpose of the Daily SCBA Checks?

Answer 5

To ensure that the SCBA is checked for proper operation prior to its use

This is crucial for the safety of personnel who will be using the equipment.

Question 9

What cleaning product must be used for SCBA facepieces?

Answer 9

CONFIDENCE PLUS® Germicidal Cleaner

This cleaner must bear the MSA™ label.

Question 10

What should be avoided when cleaning the SCBA facepiece?

Answer 10

Alcohol, hydrocarbon-based or acidic cleaning products

These can damage and degrade the materials.

Question 11

What safety equipment should be worn when handling undiluted CONFIDENCE PLUS® Germicidal Cleaner?

Answer 11

Rubber gloves and protective splash-proof goggles

This cleaner can cause skin burns and irreversible eye damage.

Question 12

What is the mixing ratio for the CONFIDENCE PLUS® Germicidal Cleaner solution?

Answer 12

30 ml of cleaner to four litres of water

This is approximately one ounce of cleaner to one gallon of water.

Question 13

How long should the facepiece soak in the sanitizer solution?

Answer 13

10 minutes

Question 14

What should be done to the facepiece after soaking in the sanitizer bath?

Answer 14

Rinse both sides thoroughly in clean, warm water

Question 15

What should NOT be done to the SCBA facepiece to dry it?

Answer 15

Do not force-dry by placing near a heater or in direct sunlight

This can cause materials to deteriorate prematurely.

Question 16

What components should be inspected after cleaning the facepiece?

Answer 16

Battery compartment and components on the I-HUD and ClearCommand® Communication device

Question 17

What method should be used to clean the harness and back-pack of the SCBA?

Answer 17

Wiped clean with a sponge/soft brush and a mild cleanser

Question 18

Which components should NOT be immersed in water during cleaning?

Answer 18

Control Module, Second Stage Regulator, Power Module

These components may be damaged if immersed.

Question 19

What should be done after cleaning and drying the SCBA?

Answer 19

Carry out the in-service equipment check as per RFPS SOP 231-04

Question 20

Fill in the blank: The SCBA facepiece should be totally immersed in the _______ sanitizer bath.

Answer 20

SCBA